Shop by Category

Ultra Thin Seiko Mini Quartz Motor

Thumb
Thumb Thumb

$14.95

Calculated at checkout

Choose Shaft Length

High Volume Pricing Available...Click Here


Buy 5-9 and save $0.45
Buy 10-24 and save $1.00
Buy 25+ and save $1.45


Free Clock Hands:

At Checkout you will be prompted to Select Your Free Set of Hands for purchasing Ultra Thin Seiko Mini Quartz Motor

Product Description

1+
$14.95
5+
$14.50
10+
$13.95
25+
$13.50


Choose Shaft Length: By Clicking on The Image

Selected Option Thumb
MVTS16
Dials Up to 1/4 in. Thick
Selected Option Thumb
MVTS22
Dials Up to 1/2 in. Thick
Selected Option Thumb
MVTS28
Dials Up to 5/8 in. Thick

Ultra Thin Seiko Mini Quartz Motor

Special Features

  • Quartz Accuracy - Stabilized quartz crystal assures high accuracy to within ±15 seconds per month.
  • Reliability - A minimum number of parts (17 in entire movement) reduces wear within the movement and assures trouble-free operation. The movement is completely enclosed in its case, so dust and dirt cannot get into the movement.
  • Compact Size - The movement is approximately 2-1/8”x 2-1/8” x 1/2”.
  • Battery Life - The movement runs approximately two years on a fresh “AA” battery, not included.
  • Step Second Motion - The second hand, if used, moves in exact one second steps.

FREE CHOICE of over 40 pairs of hour and minute hands is included. You just have to tell us what you would like. See the link to clock hands at the bottom of the movement page. Please do not assume that any clock hands you have will fit, as the mounting holes are not standardized. Mounting hole sizes and shapes are shown at the top of the clock hands link. If you do not choose a FREE pair of hands with your movement purchase and later decide that you need them, there will be a $5.00 charge for us having to make a second shipment.

These Seiko movements will operate a second hand, but second hands are considered optional. See the bottom of the movement page for the link to our selection of second hands. Seiko movements require a .034 - .035 diameter second hand bushing as shown below. This hole size is too large for many other movements..All models have a 5/16" shaft diameter so a 3/8" mounting hole is the correct size to drill in your case.



Available Accessories

The following accessories are available for the product above. You may purchase these at an additional cost, unless noted otherwise.